RuggedCom RuggedRouter RX1100 - Manual (Page 289)

34. Maintaining The Router
Revision 1.14.3 289 RX1000/RX1100™
2. Visit the Shorewall Firewall menu, Network Zones sub-menu and add the "net" and "loc"
IPv4 zones. This document defines the zone for WAN interfaces as "net" and the zone for
local interfaces as "loc".
Zone ID Zone type
net IPv4
loc IPv4
aclnt IPv4
unusd IPv4
fw Firewall System
3. Visit the Network Interfaces sub-menu and assign interfaces to the zones. For example, eth1
= net, eth2 = loc. The exact assignment will depend upon your configuration.
Note the assignment of the "aclnt" zone: Industrial Defender SAP uses OpenVPN for
secure communication between client and protected device. OpenVPN creates virtual "tunnel"
interfaces for this purpose.
Zone ID Interface Address
net eth1 detect
loc eth2 detect
unusd eth3 detect
unusd eth4 detect
aclnt tun+ detect
4. Visit the Default Policies sub-menu and assign the following policies:
Source zone Destination zone Policy
fw any ACCEPT
loc net ACCEPT
aclnt any DROP
any any DROP
5. Visit the Firewall Rules sub-menu and assign the following rules. Note that Idefender and
SAPCtl Actions must have "log to syslog level" set to "":
Action Source zone Destination
zone Protocol Src-Port Dst-Port
ACCEPT aclnt fw any
SAPCtl net fw UDP
Idefender aclnt loc any
See also the note on VRRP, Firewall Rules, and Access Manager, below.
6. Apply the Shorewall configuration.
a. For Webmin and/or SSH access to the router you can add a rule:
ACCEPT net fw tcp 22,10000