RuggedCom RuggedRouter RX1100 - Manual (Page 86)

9. Configuring Frame Relay/PPP And DDS
Revision 1.14.3 86 RX1000/RX1100™
This menu allows you to display and configure DDS Trunks. The Current Routes menu will display
the routes and status of the network interfaces.
9.2.1. DDS Network Interfaces
Figure 9.2. DDS WAN Interfaces
This menu allows you to display DDS trunks and configure the logical interfaces that run on them. A
table is presented for each interface.
Interface numbers are as described by the “DDS” labels as shown in the home page chassis diagram.
The status of both the physical interface and its corresponding logical interface is shown.
If no interfaces have been configured the menu will provide links to Frame Relay and PPP
configuration menus.
This menu presents connection statuses but does not update them in real time. Click on the Refresh
this page link to update to the current status.
The menu will change after assignment of a logical interface, providing links to logical interface and
link statistics.
Figure 9.3. DDS WAN Interfaces after logical interface assignment
9.2.1.1. Naming Of Logical Interfaces
Webmin names the logical interfaces for you (but allows you to provide a description). All interfaces
start with a “w” to identify them as wan interfaces, followed by the interface number. The next part of
the identifier is either “ppp” or “fr” and the frame relay DLCI number.