RuggedCom RuggedRouter RX1100 - Manual (Page 46)

4. Configuring The System
Revision 1.14.3 46 RX1000/RX1100™
Note
The RuggedRouter never enters a permanent shutdown state. If the RuggedRouter is instructed
to shutdown, either from Webmin or from a shell command, it will reboot into a command line shell
that waits five minutes before restarting.
If you really want the router to remain powered but permanently inactive, you must issue the shutdown,
connect a terminal to the serial port, wait for the router to enter the shutdown shell and issue a CTRL-C.
The second part of the menu allows you to program specific actions at boot time. The script will be
run after all regular boot actions have completed.
Figure 4.2. Bootup and Shutdown, Part 2
The actions may be a series of commands that can be executed at the command line. Each entered
line is executed independently of the previous line, so change directory commands will not be effective.
Always specify the absolute path of files used in commands. Selecting Save And Run Now will run
the script and show its output, allowing you to debug it.
4.3. Change Password Command
Figure 4.3. System Menu Change Password Command
This command changes only the root account password used to login to Webmin and the root account
via the serial console or SSH.