RuggedCom RuggedRouter RX1100 - Manual (Page 104)

12. Configuring PPP And the Embedded Modem
Revision 1.14.3 104 RX1000/RX1100™
%C3 - Enable MNP5 and V.42bis compression negotiation. (default)
Line quality monitoring control
%E0 - Disable line quality monitor and auto-retrain.
%E1 - Enable line quality monitor and auto-retrain.
%E2 - Enable line quality monitor and fallback/fallforward. (default)
S registers
S6=X - Wait time for dialtone detection (2-255 seconds) (default=2)
S7=X - Wait time for carrier detection (1-255 seconds) (default=50)
S8=X - Pause time for comma in dial string (0-255 seconds) (default=2)
S9=X - Carrier detect response time (50-255 * .1 seconds) (default=6)
S10=X - Loss of carrier to hangup delay (50-255 * .1 seconds) (default=14)
S11=X - DTMF tone duration (50-255 * .01 seconds) (default=95)
S29=X - Hook flash dial modifier time (0-255 * .01 seconds) (default=70)
The last three options are presented for the Internal modem only:
Country Code selects which country's dialing system to work with. If this is not set correctly the
modem might not be able to dial or connect.
Speaker Volume controls how load the modem speaker is.
Speaker Mode controls whether the speaker on the modem is on or off.
12.2.2. Modem PPP Client Connections
Figure 12.4. Modem PPP Client Connections