RuggedCom RuggedRouter RX1100 - Manual (Page 227)

24. Configuring Serial Protocols
Revision 1.14.3 227 RX1000/RX1100™
24.2.7. Serial Protocols Statistics Menu
Figure 24.9. Serial Protocols Statistics Menu
This menu presents statistics of serial port activity and established connections. The menu also allows
you to reset a port, forcing call hang-up and re-establishment.
The Port Statistics table provides a record for each active serial port. The number of historical
received and transmitted characters as well as errors will be displayed.
The Connection Statistics table reflects established TCP connections. Network and serial
connections can be paired by examining the Target Serial Port(s) field. The Status field describes
whether a network connection is established or in the process of being established.
Note
All counts are from the router's perspective. The Rx Packets count reflects packets received from
the network, the contents of which are transmitted at the protocol and reflected in the Tx Chars
field.
The Refresh button will cause the page to be reloaded.
The Continuous Display button will cause the browser to continuously reload the page showing the
differences in statistics from the last display. The difference is not a real time rate in bytes or
packets per second.
24.2.7.1. Protocol Specific Packet Error Statistics
The Raw Socket Packet Errors field reflect the number of times that a network message was received
and could not be enqueued at the serial port because of output buffering constraints. This is usually
symptomatic of a remote peer that uses a higher baud rate or local flow control.