National Instruments Graphical User Interface Ultiboard - Manual (Page 256)

Appendix A Menus and Commands
© National Instruments Corporation A-15 NI Ultiboard User Manual
Design»Polygon Splitter
Use to split a copper area or powerplane. Refer to the Splitting Copper
section of Chapter 5, Working with Traces and Copper , for more
information.
Design»Shape to Area
Use to cut out areas in a copper shape to avoid other elements within its
area. Refer to the
Converting a Copper Shape to an Area section of
Chapter 5, Working with Traces and Copper , for more information.
Design»Swap Pins
Refer to the Swapping Pins section of Chapter 5, Working with Traces and
Copper , for information.
Design»Swap Gates
Refer to the Swapping Gates section of Chapter 5, Working with Traces
and Copper , for information.
Design»Automatic Pin Gate Swap
Refer to the Automatic Pin/Gate Swapping section of Chapter 5, Working
with Traces and Copper , for information.
Design»Part Shoving
Use to toggle shoving on and off. When shoving is on, parts shove any
others out of the way when being moved or placed. Refer to the
Shoving
Parts section of Chapter 4, Working with Parts , for more information.
Design»Set Reference Point
Use to define the reference point for your board. Refer to the Setting the
Board’s Reference Point section of Chapter 3, Setting Up a Design , for
more information.
Design»Shield Nets
Use to shields nets. Refer to the Shielding Nets section of Chapter 5,
Working with Traces and Copper , for more information.