National Instruments Graphical User Interface Ultiboard - Manual (Page 251)

Appendix A Menus and Commands
NI Ultiboard User Manual A-10 ni.com
• Draw Settings—Use to toggle the Draw Settings toolbar on and off.
Refer to the
Draw Settings Toolbar section of Chapter 1, User
Interface , for more information.
• Edit—Use to toggle the Edit toolbar on and off. Refer to the Edit
Toolbar section of Chapter 1, User Interface , for more information.
• Align—Use to toggle the Align toolbar on and off. Refer to the Align
Toolbar section of Chapter 1, User Interface , for more information.
• Place—Use to toggle the Place toolbar on and off. Refer to the Place
Toolbar section of Chapter 1, User Interface , for more information.
• Select—Use to toggle the Select toolbar on and off. Refer to the Select
Toolbar section of Chapter 1, User Interface , for more information.
• Wizard—Use to toggle the Wizard toolbar on and off. Refer to the
Wizard Toolbar section of Chapter 1, User Interface , for more
information.
• Autoroute—Use to toggle the Autoroute toolbar on and off. Refer to
the
Autoroute Toolbar section of Chapter 1, User Interface , for more
information.
Place Menu
The subjects in this section describe the commands found in the Place
menu.
Place»From Database
Use to place parts from the database onto the workspace. Refer to the
Placing Parts from the Database section of Chapter 4, Working with Parts ,
for more information.
Place»Line
Use to place a line or a trace, depending on the active layer. Refer to the
Placing Shapes and Graphics of Chapter 4, Working with Parts , and the
Placing a Trace: Manual Method section of Chapter 5, Working with
Traces and Copper , for more information.
Place»Select
Use to change from placing elements to selecting elements.