National Instruments Graphical User Interface Ultiboard - Manual (Page 177)

Chapter 5 Working with Traces and Copper
© National Instruments Corporation 5-33 NI Ultiboard User Manual
Copying a Copper Route
You can copy the routing of traces between two identical parts groups that
have been set up using the Group Replica command.
Complete the following steps to copy copper routing between groups:
1. Create two identical part groups. Refer to the Replicating a Group
section of Chapter 4, Working with Parts , for more information.
2. Route the traces for one of the groups. In the example below, Part
Group A consists of U7 and U8. Part Group B consists of U9 and U10.