Primera Technology Fujitsu Tape Drive RX300 S2 - Manual (Page 88)

88
Chapter 3 OS Installation Using ServerStart
●
Remote Installation Using a Remote Resource Server
In remote installation using a remote resource server, ServerStart starts up on the target server.
Procedures for starting installation are the same as those in normal installation (preconfiguration mode,
guided mode, and expert mode). Once installation started, resources necessary for installation are
provided from the remote resource server. Thus, procedures such as inserting a CR-ROM are not
necessary.
3.4.2 System Requirements for Remote Resource/PXE
Servers
Because remote installation is performed via a network, the environment must have at least one
Windows server and a local area network.
In addition, the following environment is required.
■ Remote Resource/PXE Server Requirements
Notes on the PXE server
Check that no other PXE server exists on the same LAN.
Servers installed with software with the PXE function such as SystemcastWizard/SystemcastWizard
Professional, Quick Recovery Manager, or the Microsoft RIS function cannot be used as a PXE server.
table: System Requirements for Remote Resource/PXE Servers
PXE server Remote resource server
OS Windows 2000 Server SP2 -SP4 Windows Server 2003
Windows 2000 Server
Windows NT Server 4.0
Memory
modules 256MB or more 256MB or more
Operating
environment • DHCP server function (required on the same
network)
• File sharing function (required)
• File sharing function (required)
Target server
Remote resource server
Activate ServerStart
and start installation
1) Request resources
Supply resources 2)
- OS
- Service Pack
- Application
etc.