Primera Technology Fujitsu Tape Drive RX300 S2 - Manual (Page 279)

279
PRIMERGY RX300 S2 User’s Guide
9
O
p
eration
a
nd
Mainten
ance
When only the user or administrator password is set, the same setting items are accessible to both
users and administrators.
When both passwords are set, users can set dates and user passwords only.
■ Deleting / Changing Password
To delete or change a password, select [Set System Password] or [Set Setup Password] from the
[Security] menu.
1
Enter the current password in the [Enter Current Password] field in the
password entry window.
2
Enter a new password in the [Enter New Password] field.
To delete the password, enter nothing and perform Step 4.
3
In the [Confirm New Password] field, enter the password you have entered in
Step 2.
To delete the password, enter nothing and perform Step 4.
4
Press the [Enter] key.
When you delete the password, [System Password] or [Setup Password] on the [Security] menu
shows [Not installed].
The system shuts down after three invalid password entries. If this happens, power off the server, turn
it back on, and then enter the correct password.
If you forgot your password and cannot start the server, change the switch block setting on the
baseboard to reset the passwords ( "8.1 Switch Block Settings" (pg.222)).
Then return the switch block to the original setting, and then set the password using this utility.
Set Setup(System) Password
Enter Current Password [ ]
Confirm New Password [ ]
Enter New Password [ ]