Primera Technology Fujitsu Tape Drive RX300 S2 - Manual (Page 150)

150
Chapter 5 Operations after OS Installation
5.5 Notes Before Operating the
Server
This section explains the settings required before starting to operate the server.
For the respective settings, refer to "First Step Guide".
• If a LAN card was added, install a driver according to "4.3 Installing the LAN Driver" ( pg.124).
• When connecting a SCSI optional device (such as a hard disk cabinet or DAT), connect it according
to "Chapter 7 Installing Internal Options" ( pg.171).
• For the settings for the installed applications supplied with the product, refer to the manuals of each
application.
5.5.1 Updating the System
■ Windows Update
The system being used must be updated to prevent potential problems in the system.
Executing Windows Update can automatically search the latest version of QFE applicable to the OS and
update the system to the latest status. Execute Windows Update periodically.
Executing Windows Update requires a network environment connectable to the Internet.
5.5.2 Auto-run Function from CD-ROM Drives
Perform the following procedures to change the settings of the auto-run function from the CD-ROM
drives after server installation.
1
Make the registry editable, and change the value of AutoRun of the following
registry key:
HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\CDRom
To enable auto-run, set the value of Autorun to "1", and to disable auto-run, set the value to "0".
2
Restart the system.
The setting is enabled after the system is restarted.