Primera Technology Fujitsu Tape Drive RX300 S2 - Manual (Page 32)

32
Chapter1 Overview
1
Open the rack door.
2
Make sure that the floppy disk drive and CD-ROM drives are empty.
3
Turn on the display and peripheral devices.
4
Press the power switch on the front of the server.
The server's power LED is lit green. When the power is turned on, the server performs Power On
Self Tests (POST). If any abnormalities are detected by POST, error messages are displayed.
"9.2.2 Error Messages" (pg.260)
The time to turn on/off the server can be set with the ASR setting (on the [Power On/Off] tab) using
ServerView supplied with this server.
For details, refer to "3.2 Settings for Server Monitoring" in "ServerView User's Guide" on the
PRIMERGY Document & Tool CD (Disc 2).
It may take a few seconds until the server to power on after pressing the power switch.
Power switch
The server's power
LED is lit green