Primera Technology Fujitsu Tape Drive RX300 S2 - Manual (Page 117)

117
PRIMERGY RX300 S2 User’s Guide
4
Manu
al O
S
In
st
allation
4.2 Starting Manual Installation
This section explains the procedures for installing the OS manually.
4.2.1 Installing Windows Server 2003
1
Create driver disks.
Prepare necessary drivers before installing Windows Server 2003.
Some drivers are created from the ServerStart CD-ROM. For how to create driver disks, refer to
"4.1 Creating Driver Disks" ( pg.112).
2
Insert the Windows Server 2003 CD-ROM.
Turn on the server and insert the Windows Server 2003 CD-ROM immediately into the CD-ROM
drive. Check there are no floppy disks in the floppy disk drive. When the active area is specified
on the hard disk, the following message appears.
Pressing any key while this message is displayed boots the system from the CD-ROM.
3
The [Windows Server 2003 Setup] window appears.
Immediately, the following message appears at the bottom of the window. Press the [F6] key.
This message will be displayed for a short time after the setup window (blue screen) appears.
Press the [F6] key immediately after the window turns blue.
4
Install the drivers manually.
1. When the following message appears, press the [S] key.
Press any key to boot from CD....
Press F6 if you need to install a third party
SCSI or RAID driver ...
To specify additional SCSI adapters, CD-ROM drives,
or special disk controllers for use with Windows,
including those for which you have a device
support disk from a mass storage device
manufacturer, press S.