Primera Technology Fujitsu Tape Drive RX300 S2 - Manual (Page 62)

62
Chapter 3 OS Installation Using ServerStart
3.1.4 Disk wizard
Create and format hard disk partitions.
The disk wizard starts up with the default settings. Be sure to click [MODIFY] to check the settings.
Change them as necessary.
1
Click [Disk Wizard: Hard disk partitioning and formatting].
The [Disk Overview] window appears.
When the installation disk has partitions, check [Erase all existing partitions on all displayed
disks].
When other disks than the installation disk have an active partition, create a partition on the
disks with an active partition and check [Erase all existing partitions on all displayed disks].
2
Add, remove, or modify partitions as necessary.
Partition size of the FAT file system
When "FAT" is selected in [File system] and a value equal to or more than 4095MB or "Auto-
matic setting" is specified in [Partition size], the size of created partitions will be 4095MB.
The following limits apply to the volume label length. A volume label longer than the limit may
be used. However, it can cause installation failure. Enter a volume label within the limit.
•FAT: Up to 11 byte characters
•NTFS: Up to 32 byte characters