Paradyne ACCULINK 336x E1 - Manual (Page 48)

Operation
3-27 3360-A2-GB20-20 December 1996
NOTE
The following procedures are
examples only. Screen displays
may vary depending on the
model and configuration of the
E1 NTU.
Displaying DS0 Channel Assignments
Use the Display command (in the Channel
Configuration branch) to view how the DS0 channels are
currently allocated.
Line 1 of the display shows the 31 channels of the
selected interface. Pressing the or key scrolls the
channels onto the screen in groups of three. Line 2
displays what is allocated to the DS0 channel listed in
Line 1. Symbols used in the display are shown in
Table 3-5 .
Table 3-5
Display Channel Symbols
Symbol Meaning
– The DS0 channel is not allocated.
Prt n The DS0 channel is allocated to Port n,
where n is 1, 2, 3, or 4.
N n The DS0 channel is allocated to the
network interface DS0 channel
n, where
n can be any number from 1 through 31.
D n The DS0 channel is allocated to the
G.703 DTE interface DS0 channel
n,
where n can be any number from 1
through 31.
To display the DS0 channel allocation,
1. From the top-level menu screen, select Cnfig.
2. Select the configuration option set to be copied
into the Edit area by using the appropriate
Function key. Use the scroll keys, if necessary.
3. Select Edit.
4. From the Edit screen, press the key until the
Chan selection appears on the screen.
5. Select Chan.
F1
Edit:
Port
NET Chan
F2 F3
6. From the Channel Config screen, select Dsply
(display).
F1
Channel Config:
Dsply
Clear DTE
F2 F3
7. From the Display Chan screen, select NET to
display the channels allocated to the network
interface.
F1
Display Chan:
NET
DTE Ports
F2 F3
Or, select DTE to display the channels allocated to
the G.703 DTE interface.
F1
Display Chan:
NET
DTE Ports
F2 F3