Patton electronic G.SHDSL INTEGRATED 3086 - Manual (Page 55)

Using the 3086 as a simple modem (TDM data over DSL) 55
Model 3086 G.SHDSL Integrated Access Device User Guide 4 • Basic Application Configurations
fi gshdsl set pcmmode Serial
fi gshdsl set ghsannex AnnexB
fi gshdsl set serialTS 32
fi system config save
Wait for 'configuration saved' message…
Saving configuration…
fi
fi Configuration saved.
3086 B CLI configuration
Note Press the Enter key at the end of each command line.
fi gshdsl set terminal remote
fi gshdsl set dslrateTS 32
fi gshdsl set interface hdlc
fi gshdsl set pcmmode Serial
fi gshdsl set ghsannex AnnexB
fi gshdsl set serialTS 32
fi system config save
Wait for 'configuration saved' message…
Saving configuration…
fi
fi Configuration saved.
Note When connecting to Patton Electronics Model 3096RC Central
Office T-DACS, The model 3086 must be configured as CP
(Remote). Check the 3096RC user manual for information on the
configuration of the 3096RC.