Dip switch configuration, Cli configuration, 3086 a cli configuration – Patton electronic G.SHDSL INTEGRATED 3086 User Manual
Page 54: Dip switch configuration cli configuration
4 • Basic Application Configurations
Model 3086 G.SHDSL Integrated Access Device User Guide
54
Using the 3086 as a simple modem (TDM data over DSL)
Using the 3086 as a simple modem (TDM data over DSL)
Serial port connection only, Ethernet port not used to send data over DSL but can be used for management.
There are three ways to configure the 3086 for serial port operation only:
•
Via DIP switches
•
Via the console port (using the command line interface or CLI)
•
Via the Ethernet port using Telnet, Web browser, or SNMP tools.
For point-to-point operation (two 3086s connected directly) at 2.048 Mbps, follow the next example:
DIP Switch Configuration
Set switch S2-8 from On to Off, wait 3 to 4 seconds set it back to On.
CLI configuration
When using the console port, or Telnet session via Ethernet port, the user has access to the 3086 command line
interface (CLI). The above configuration can be entered via the CLI as follows:
3086 A CLI configuration
Note
Press the Enter key at the end of each command line.
fi
gshdsl set terminal central
fi
gshdsl set dslrateTS 32
fi
gshdsl set interface hdlc
3086 A
3086 B
Switch Setting Condition Switch Setting Condition
S2-1
On
2.048 Mbps
S2-1
On
2.048 Mbps
S2-2
Off
S2-2
Off
S2-3
On
S2-3
On
S2-4
On
S2-4
On
S2-5
On
S2-5
On
S2-6
On
S2-6
On
S2-7
On
S2-7
On
S2-8
On
S2-8
On
S3-1
On
CO
S3-1
Off
CP
S3-3
Off
Int. clock
S3-3
Off
Int. Clock
S3-6
On
Annex B
S3-6
On
Annex B