Patton electronic G.SHDSL INTEGRATED 3086 - Manual (Page 167)

Administering user accounts 167
Model 3086 G.SHDSL Integrated Access Device User Guide E • Command Line Interface (CLI) Operation
Enter the new password twice as prompted:
Enter new password: ***
Again to verify: ***
fi
Note No check is made for any current password which may have been set
for the user.
If you wish to change the password for another user, enter the command:
user change
This command logs you into the system as another user. You can then use the user password command to
change the password for this user.
Note Changing to another user means that you lose all superuser privileges.
Note Only superusers can use the user change command.
Changing user settings
To change any of the default settings for a user, use the following commands. For example, to change the set-
tings for user fred:
system set user fred access {default|engineer|superuser}
system set user fred maydialin {enabled|disabled}
system set user fred mayconfigure {enabled|disabled}
For example, to change the security level for fred, enter:
system set user fred access engineer
Note Only superusers can use the user change command.
Controlling login access
To set user login access for user username, use the command (all on one line):
system set login < username > access {default|engineer|superuser}
Controlling user access
To set user access for user username, use the command (all on one line):
system set user < username > access {default|engineer|superuser}
G.SHDSL Commands:
Command format: ‘gshdsl Action Attribute Value’
• Action – Two types of actions are available: ‘set’ or ‘show’
• Set – set attributes with a value.
• Show – get information from the box
• Attribute – The name of the attributes to access.
• Value – The new value for the attribute (Set command only)