T1 interface configuration, Dip switch configuration, Switch bank s2 – Patton electronic G.SHDSL INTEGRATED 3086 User Manual
Page 45
T1 Interface
45
Model 3086 G.SHDSL Integrated Access Device User Guide
4 • Basic Application Configurations
T1 Interface Configuration
The 3086 T1 interface can be configured via DIP switches, HTTP/SNMP, or command line interface (CLI).
This section discusses DIP switches and HTTP (web server) configuration. For CLI, see Appendix D, “Com-
mand Line Interface (CLI) Operation” on page 163.
DIP Switch Configuration
Switch configuration in the 3086 is to be used in situations where the 3086 functions as a DSL modem carry-
ing TDM (T1) data only without resorting to the use of a PC for configuration.
Note
The Model 3086 is shipped with all DIP switches set to the ON posi-
tion. While in this setting, the Model 3086 can be configured only
via software (console, Telnet, HTTP, SNMP). If you want to use the
DIP switches to configure the Model 3086, see section “Switch S2-8”
on page 43 to activate the DIP switch configuration option.
The Model 3086 includes two eight-DIP switch banks labeled S2 and S3. They are externally accessible by
removing the plate on the bottom side of the unit.
Switch Bank S2
Table 6 shows the default configuration for switch S2. A description of S2 options follows the table.
Table 6. S2 Summary Table
Switch Position
Function
Factory Default
Selected Option
S2-1
Data Rate
On
Not a valid rate
S2-2
On
S2-3
On
S2-4
On
S2-5
On
S2-6
On
S2-7
On
S2-8
Switch configuration
On
Toggle On->Off>On
To activate DIP configuration