Panasonic 470 - Manual (Page 42)

42 Chapter 2 Configuring network monitoring using CLI
show port-statistics command
The show port-statistics command displays the statistics for the
port on both received and transmitted traffic. The syntax for the show
port-statistics command is:
show port-statistics [port ]
The show port-statistics command is in the config-if command
mode.
Table 13 "show port-statistics command parameters and variables"
(page 42)
describes the parameters and variables for the show
port-statistics command.
Table 13
show port-statistics command parameters and variables
Parameters and
variables
Description
port Specifies the port numbers for which to display
statistics.
Note: If you omit this parameter, the system uses the
port number specified with the
interface command.
Figure 11 "show port-statistics command output" (page 43) displays sample
output from the show port-statistics command.
Nortel Ethernet Switch 460/470
Configuration — System Monitoring
NN47210-503 01.01 Standard
3.7 22 February 2007
Copyright © 2005-2007, Nortel Networks Nortel Networks Confidential
.