No logging remote enable command, Logging remote address command, No logging remote address command – Panasonic 470 User Manual
Page 37
Enabling remote logging
37
no logging remote enable command
The
no logging remote enable
command disables sending syslog
messages to a remote server. The syntax for the
no logging remote
enable
command is:
no logging remote enable
The
no remote logging enable
command is in the config command
mode.
The
no remote logging enable
command has no parameters or
variables.
logging remote address command
The
logging remote address
command sets the remote server for
receiving the syslog messages; you enter the IP address of the server you
want. The syntax for the
logging remote address
command is:
logging remote address
The
logging remote address
command is in the config command
mode.
Table 10 "logging remote address command parameters and variables"
(page 37)
describes the parameters and variables for the
logging
remote address
command.
Table 10
logging remote address
command parameters and variables
Parameters and
variables
Description
Specifies the IP address of the remote server in
dotted-decimal notation.
The default address is 0.0.0.0.
no logging remote address command
The
no logging remote address
command clears the IP address of
the remote server. The syntax for the
no logging remote address
command is:
no logging remote address
The
no logging remote address
command is in the config command
mode.
Nortel Ethernet Switch 460/470
Configuration — System Monitoring
NN47210-503
01.01
Standard
3.7
22 February 2007
Copyright © 2005-2007, Nortel Networks
Nortel Networks Confidential
.