Panasonic 470 - Manual (Page 35)

Enabling remote logging 35
Table 8 "clear logging command parameters and values" (page 35) shows
the parameters and values for the clear logging command.
Table 8
clear logging command parameters and values
Parameters and values Description
nv Clears all log messages in both DRAM and
non-volatile memory (NVRAM).
Enabling remote logging
This feature provides an enhanced level of logging by replicating system
messages onto a syslog server. System log messages from several
switches can be collected at a central location, which alleviates the network
manager querying each switch individually to interrogate the log files. This
section covers the following commands:
• "show logging" (page 35)
• "logging remote enable command" (page 36)
• "no logging remote enable command" (page 37)
• "logging remote address command" (page 37)
• "no logging remote address command" (page 37)
• "logging remote level command" (page 38)
• "no logging remote level command" (page 38)
• "default logging remote level command" (page 39)
show logging
The show logging command displays the configuration and the current
contents of the system event log. The syntax for the show logging
command is:
show logging [config] [critical] [informational] [serious]
[sort-reverse]
The show logging command is in the privExec command mode.
Nortel Ethernet Switch 460/470
Configuration — System Monitoring
NN47210-503 01.01 Standard
3.7 22 February 2007
Copyright © 2005-2007, Nortel Networks Nortel Networks Confidential
.