Panasonic 470 - Manual (Page 38)

38 Chapter 2 Configuring network monitoring using CLI
The no logging remote address command has no parameters or
variables.
logging remote level command
The logging remote level command sets the severity level of the
logs you send to the remote server. The syntax for the logging remote
level command is:
logging remote level {critical | informational | serious}
The logging remote level command is in the config command mode.
Table 11 "logging remote level command parameters and variables" (page
38)
describes the parameters and variables for the logging remote
level command.
Table 11
logging remote level command parameters and variables
Parameters and
variables
Description
{critical | serious |
informational} Specifies the severity level of the log messages sent
to the remote server:
• critical
• informational
• serious
There is no default value for this command.
no logging remote level command
The no logging remote level command removes any severity level of
the log messages that you send to the remote server; it reverts to None.
The syntax for the
no logging remote level command is:
no logging remote level
The no logging remote level command is in the config command
mode.
The no logging remote level command has no parameters or
variables.
Nortel Ethernet Switch 460/470
Configuration — System Monitoring
NN47210-503 01.01 Standard
3.7 22 February 2007
Copyright © 2005-2007, Nortel Networks Nortel Networks Confidential
.