Panasonic 470 - Manual (Page 40)

40 Chapter 2 Configuring network monitoring using CLI
port-mirroring command
The port-mirroring command sets the port mirroring configuration. The
syntax of the port-mirroring command is:
port-mirroring mode
{disable |
Xrx monitor-port mirror-port-X |
Xtx monitor-port mirror-port-X |
XrxOrXtx monitor-port
mirror-port-X mirror-port-Y |
XrxOrYtx monitor-port
mirror-port-X mirror-port-Y |
XrxYtx monitor-port
mirror-port-X mirror-port-Y |
XrxYtxOrYrxXtx monitor-port
mirror-port-X mirror-port-Y |
Asrc monitor-port mirror-MAC-A |
Adst monitor-port mirror-MAC-A |
AsrcOrAdst monitor-port
mirror-MAC-A |
AsrcBdst monitor-port
mirror-MAC-A mirror-MAC-B |
AsrcBdstOrBsrcAdst monitor-port
mirror-MAC-A mirror-MAC-B }
Note: In this command, portlist must specify only a single port.
The port-mirroring command is in the config command mode.
Table 12 "port-mirroring command parameters and variables" (page
40)
describes the parameters and variables for the port-mirroring
command.
Table 12
port-mirroring command parameters and variables
Parameters and
variables
Description
disable Disables port mirroring.
monitor-port Specifies the monitor port.
mirror-port-X Specifies the mirroring port X.
mirror-port-Y Specifies the mirroring port Y.
mirror-MAC-A Specifies the mirroring MAC address A.
mirror-MAC-B Specifies the mirroring MAC address B.
portlist Enter the port number.
Xrx Mirror packets received on port X.
Nortel Ethernet Switch 460/470
Configuration — System Monitoring
NN47210-503 01.01 Standard
3.7 22 February 2007
Copyright © 2005-2007, Nortel Networks Nortel Networks Confidential
.