Panasonic 470 - Manual (Page 34)

34 Chapter 2 Configuring network monitoring using CLI
Parameters and variables Description
level critical | serious |
informational
Specifies the level of logging stored
in DRAM.
nv-level
critical | serious |
informational | none
Specifies the level of logging stored
in NVRAM.
no set logging
The no set logging command disables the system event log for the
Ethernet Switch 470-48T or the Ethernet Switch 460-24T. The syntax for
the
no set logging command is:
no set logging
The no set logging command is in the config command mode.
The no set logging command has no parameters or variables.
default logging
The default logging command configures the system settings as the
factory default settings for the system event log on the Ethernet Switch
470-24T. The syntax for the
default logging command is:
default logging
The default logging command is in the config command mode.
The default logging command has no parameters or variables.
default set logging
The default set logging command configures the system settings as
the factory default settings for the system event log on the Ethernet Switch
470-48T or the Ethernet Switch 460-24T. The syntax for the
default set
logging command is:
default set logging
The default set logging command is in the config command mode.
The default set logging command has no parameters or variables.
clear logging command
The clear logging command clears all log messages in DRAM. The
syntax for the clear logging command is:
clear logging [nv]
The clear logging command is in the privExec command mode.
Nortel Ethernet Switch 460/470
Configuration — System Monitoring
NN47210-503 01.01 Standard
3.7 22 February 2007
Copyright © 2005-2007, Nortel Networks Nortel Networks Confidential
.