Panasonic 470 - Manual (Page 36)

36 Chapter 2 Configuring network monitoring using CLI
Table 9 "show logging command parameters and variables" (page 36)
describes the parameters and variables for the show logging command.
Table 9
show logging command parameters and variables
Parameters and
variables
Description
config Displays the configuration of event logging.
critical Displays critical log messages.
informational Displays informational log messages.
serious Displays serious log messages.
sort-reverse Displays log messages in reverse chronological order
(beginning with most recent).
Figure 9 "show logging config command output" (page 36) shows the output
of the show logging config command.
Figure 9
show logging config command output
logging remote enable command
Note: The default value for remote logging is disabled.
The logging remote enable command enables logging syslog
messages to a remote server. The syntax for the remote logging
enable command is:
logging remote enable
The logging remote enable command is in the config command mode.
The logging remote enable command has no parameters or variables.
Nortel Ethernet Switch 460/470
Configuration — System Monitoring
NN47210-503 01.01 Standard
3.7 22 February 2007
Copyright © 2005-2007, Nortel Networks Nortel Networks Confidential
.