Pitney Bowes DM125 - Manual (Page 149)

10-7
10 • Maintenance
SV62276 Rev. A
2. Separate wick from metal holder, clean the wick in plain water,
and rinse thoroughly. Blot the wick with a paper towel to remove
excess water
3. Place the wick back in the holder.
4. Reinstall the wick and holder assembly into moistener. Be sure
to seat the holder against the top of the wick.
5. Reinstall the moistener. Push down on the blue release lever on
the moistener.
Removing and Cleaning the Moistener Wick and Holder
i NOTE: This procedure assumes you have done steps 1 to 7 from
the previous "Removing and Cleaning the Moistener Brush" section.
6. Slide the moistener back onto the machine. You should hear a
click as it engages.
Wick
Holder
Release
Lever
CLICK!
1. Pull up and remove the holder and wick from the moistener as
shown here.
Maintaining the Moistener