Pitney Bowes DM125 - Manual (Page 148)

10-6
10 • Maintenance
SV62276 Rev. A
5. Clean the brush in plain water, and rinse thoroughly. Blot the
brush with a paper towel to remove excess water
6. Position the brush as shown at
right so its bottom edge is under
the mounting tabs.
7. Slide the brush back toward the
rear of the moistener.
i NOTE: At this point, if you need to clean the wick and holder,
go to" Removing and Cleaning the Moistener Wick and Hold-
er" procedure on the next page. Otherwise, just continue
with step 8.
CLICK!
Release
Lever
8. Reinstall the moistener. Push down on the blue release lever on
the moistener.
Removing and Cleaning the Moistener Brush (cont'd)
9. Slide the moistener back onto the machine. You should hear a
click as it engages.
3. Open the hinged brush holder.
4. Grasp the bristles and slide the
brush out of the hinged brush
holder, toward the front of the
moistener tank.
Brush Holder Brush
Maintaining the Moistener