Polycom WEBCOMMANDER 8 - Manual (Page 325)

MGC WebCommander User’s Guide
10-39
The Conference Properties - Meeting Me Per Conference window
opens.
In this window you assign dial-in numbers to the conference. Callers
wishing to participate in such a conference must dial one of the dial-in
numbers, and will be automatically connected to the appropriate
conference. The conference participants do not have to be defined prior
or during the conference settings – they are automatically detected and
are assigned the conference parameters. Using this mode, any participant
who dials the conference number can connect to the conference until all
the MCU resources are utilized, or the maximum number of participants
is reached.
When the participant connects to the conference, all the channels with
the same CLI number are identified as pertaining to the same participant.
In H.221, all the channels must have the same CLI number (applicable to
2B only). In BONDING, this rule is not relevant, and each incoming call
is identified as a new participant.
The definition of a Meeting Room conference is based on the “Meet Me
Per Conference” settings with additional, specific parameters. Make sure
that the Auto Terminate option in the Advanced window is checked and
that the parameters are set accordingly.