1 click remote setting>alarm>alarm parameters, 2 configure the following, 3 click apply to save your settings – LOREX Technology Lorex Digital Video Surveillance Recorder lh1 10 User Manual
Page 85: Configuring alarm parameters

71
Remote Viewing
Configuring Alarm Parameters
The Alarm parameters menu allows you to select the type of events that will trigger the
system to "beep" during an alarm event.
To configure alarm parameters:
1
Click Remote Setting>Alarm>Alarm Parameters.
2
Configure the following:
• Buzzer Time: Select the duration the system beeps if the DVR detects an alarm event. Choose
from 10 - 60 seconds.
• Select the type of events that will trigger an alarm:
• MD Alarm (motion detection)
• HDD Loss: Hard Drive loss
• HDD Space: Low Hard Drive Space
• Video Loss
• Select the Email check box if you want the system to send e-mail notifications if the system
detects alarm events.
• Select the Full Screen check box if you want the system to go into full screen mode when the
system detects alarm events.
• Post Recording: Select the post recording time after an alarm event triggers the an alarm.
• Pre Record: Select the pre recording time when the system detects an alarm trigger.
3
Click Apply to save your settings.