Lucent Technologies PortMaster User Manual
Portmaster, Configuration guide
Table of contents
Document Outline
- About This Guide
- Introduction 1
- How the PortMaster Works 2
- Configuring Global Settings 3
- Setting the System Name
- Setting the Administrative Password
- Setting the Dynamic Host Control Protocol (DHCP) Server
- Setting the Default Route Gateway
- Configuring Default Routing
- Configuring Name Resolution
- Setting the Telnet Port
- Setting the Number of Management Application Connections
- Setting System Logging
- Setting Administrative Logins to Serial Ports
- Configuring an IP Address Pool
- Setting the Reported IP Address
- Configuring SNMP
- Displaying the Routing Table
- Setting Static Routes
- Enabling NetBIOS Broadcast Packet Propagation
- Setting Authentication for Dial-In Users
- Setting Call-Check Authentication
- Setting the ISDN Switch
- Configuring the Ethernet Interface 4
- Configuring an Asynchronous Port 5
- Asynchronous Port Uses
- General Asynchronous Port Settings
- Overriding Certain Port Settings
- Setting the Port Speed
- Parity Checking
- Setting Databits
- Setting Flow Control
- Setting the Dial Group
- Displaying Extended Port Information
- Setting the Login Prompt
- Setting the Login Message
- Setting an Optional Access Filter
- Setting Port Security
- Allowing Users to Connect Directly to a Host
- Setting a Port as the Console
- Setting the Port Idle Timer
- Configuring a PortMaster for Login Users
- Configuring a Port for Access to Shared Devices
- Configuring a Port for Network Access
- Configuring a Port for a Dedicated Connection
- Connecting without TCP/IP Support
- Configuring a Synchronous WAN Port 6
- Configuring Dial-In Users 7
- Configuring Dial-Out Connections 8
- Configuring the Location Table
- Creating a Location
- Setting the Connection Type
- Setting the Telephone Number
- Setting the Username and Password
- Setting the Protocol
- Setting the Destination IP Address
- Setting the Destination Netmask
- Setting the IPX Network Number
- Setting RIP Routing
- Setting the Dial Group
- Setting the MTU Size
- Configuring Compression
- Setting the Idle Timer
- Setting Data over Voice
- Setting CHAP
- Setting the Asynchronous Character Map
- Setting Multiline Load Balancing
- Setting Filters
- Testing Your Location Configuration
- Configuring the Location Table
- Configuring Filters 9
- Using Modems 10
- Configuring the PortMaster 3 11
- Using ISDN BRI 12
- Using Frame Relay 13
- Using Synchronous V.25bis Connections 14
- Using Office-to-Office Connections 15
- Using Internet Connections 16
- Providing User Dial-In Access 17
- Accessing Shared Devices 18
- Using Synchronous Leased Lines 19
- Networking Concepts A
- TCP and UDP Ports and Services B
- Glossary
- Command Index
- Subject Index