Lucent Technologies PortMaster User Manual
Page 275
Providing User Dial-In Access
17-11
Configuration Steps for Dial-In Access
3.
If everything connects as expected, turn off debugging and save the
configuration.
Command> set debug off
Command> save all
4.
If you notice a problem, do the following:
a.
Reset the port.
b.
Check your configuration.
c.
Dial the PortMaster again.
d.
Repeat this procedure until the connection is made correctly.
5.
When you have configured the PortMaster correctly, reset the ports and
save the configuration.
Command> reset all
Command> save all
See also other documents in the category Lucent Technologies Hardware:
- 9076 (150 pages)
- CELLPIPE 7820-0766-004 (48 pages)
- AnyMedia Line Access Gateway (4 pages)
- CellPipe 22A Series (2 pages)
- Stinger MS+DSL (2 pages)
- ATM Module 8-Port DS3/E3 (2 pages)
- Web Services Gateway OmniAccess 8550 (8 pages)
- 7820-0657-001 (34 pages)
- Alcatel-Lucent VPN 1200 (6 pages)
- Stinger STGRSACR-SO-ADSL2P (2 pages)
- 106433691 (7 pages)
- 2000 (2 pages)
- VPN Firewall Brick 20 (4 pages)
- 20A-USB (2 pages)
- GW-DS300N (78 pages)
- Network Access Module (75 pages)
- Wavelength Extension Solution Metropolis (4 pages)
- Lucent Network Gateway (2 pages)
- 20H (2 pages)
- 5800 Series (88 pages)
- Cajun Switch P550R (41 pages)
- 2300 (2 pages)
- Multiplexer and Transport System ADM 16/1 (8 pages)
- Cajun M770 (72 pages)
- DSL Element Management System NavisAccess (4 pages)
- Ethereal (199 pages)
- 3000 (586 pages)
- CellPipe 55 Series (2 pages)
- Telephone User Interface Serenade (2 pages)
- APX 1000 (4 pages)
- PacketStar PSAX (4 pages)
- DSL Access Concentrator Stinger FS+ (4 pages)
- USS-720 (96 pages)
- AnyMedia 4300 (2 pages)
- CellPipe 40H-CES (2 pages)
- Stinger Trunk Module OC-12/STM-4 (2 pages)
- Host-Based Controller Modem AT (87 pages)