Lucent Technologies PortMaster - Manual (Page 258)

Configuration Steps for an Internet Connection
16-6 PortMaster Configuration Guide
Leave all other settings at their default values.
After configuring the serial port, enter the following commands to reset the port and
save the configuration:
Command> reset s1
Command> save all
For more information about asynchronous ports and configuring modems, refer to
Chapter 5, “Configuring an Asynchronous Port.”
Serial Port Settings for a Hardwired Connection
To establish a hardwired connection on a serial port, configure the port with the values
shown in Table 16-4.
Leave all other settings at their default values. After configuring the serial port, enter the
following commands to reset the port and save the configuration:
Command> reset s1
Command> save all
Table 16-4 Serial Port Values for a Hardwired Port
Setting Command
Port type set s1 network hardwired
Protocol set s1 protocol ppp
MTU set s1 mtu 1500
Speed 1 set s1 speed 1 115200
Modem control set s1 cd on
Hardware flow control set s1 rts/cts on
Software flow control set s1 xon/xoff off
IP destination set s1 destination 192.168.5.6
Netmask set s1 netmask 255.255.255.0
RIP routing set s1 rip off
Compression set s1 compression on