Lucent Technologies PortMaster - Manual (Page 203)

Using ISDN BRI 12-19
ISDN BRI Unnumbered IP Configuration Example
Configuring a Dial-Out Location
A location entry on the PortMaster in San Francisco must be created for the location
identified as denver. This allows the PortMaster router in San Francisco to call the
PortMaster in Denver when network traffic is queued. The new location denver should
be configured with the values shown in Table 12-12.
Table 12-12 Location Table Values
Setting Command
Location name add location denver
Type set location denver manual
(Set the location for manual dialing until after the
configuration has been tested. Once the configuration is
verified, change the connection type to on-demand.)
Protocol set location denver ppp
IP destination set location denver destination 192.168.200.1
Netmask set location denver netmask 255.255.255.0
IPX network set location denver ipxnet F3
RIP routing set location denver rip on
MTU set location denver mtu 1500
Idle timer set location denver idle 2
Dial group set location denver group 2
Username set location denver username sf
Telephone number set location denver telephone 5551212
Password set location denver password anypasswd
High-water mark set location denver high_water 0
Maximum ports set location denver maxports 1