Lucent Technologies PortMaster - Manual (Page 228)

Configuration Steps for a Synchronous V.25bis Connection
14-6 PortMaster Configuration Guide
After you configure user table settings as shown in Table 14-4, enter the following
command to save the configuration:
Command> save all
No compression is used on synchronous lines. For more information about configuring
user table settings, refer to Chapter 7, “Configuring Dial-In Users.”
Configuring a Dial-Out Location
A location entry on the PortMaster in Boston must be created for the location identified
as miami. This allows the PortMaster in Boston to call the PortMaster in Miami when
network traffic is queued. The new location miami should be configured on the router in
Boston with the values shown in Table 14-5.
IPX network set user miami ipxnet F3
RIP routing set user miami rip on
MTU set user miami mtu 1500
Table 14-5 Location Table Values
Setting Command
Location name add location miami
Type set location miami manual
(Set the location for manual dialing until after the
configuration has been tested. Once the configuration is
verified, change the connection type to on-demand.)
Protocol set location miami ppp
IP destination set location miami destination 192.168.1.1
Netmask set location miami netmask 255.255.255.0
IPX network set location miami ipxnet F3
RIP routing set location miami rip on
MTU set location miami mtu 1500
Table 14-4 User Table Values (Continued)
Setting Command