Lucent Technologies PortMaster - Manual (Page 257)

Using Internet Connections 16-5
Configuration Steps for an Internet Connection
After configuring the Ethernet interface, enter the following commands to reset it and
save the configuration:
Command> reset ether0
Command> save all
For more information on Ethernet interface parameters, refer to Chapter 4,
“Configuring the Ethernet Interface.”
Serial Port Settings for Dial-Out
For continuous dial-out on a serial port, configure the port with the values shown in
Table 16-3.
Table 16-2 Ethernet Port Parameter Values
Setting Command
IP address set ether0 address 192.168.200.1
Netmask set ether0 netmask 255.255.255.0
Broadcast address set ether0 broadcast high
Table 16-3 Serial Port Values for Continuous Dial-Out
Setting Command
Port type set s1 network dialout
Protocol set s1 protocol ppp
Speed 1 set s1 speed 1 115200
Speed 2 set s1 speed 2 115200
Speed 3 set s1 speed 3 115200
Modem control set s1 cd on
Hardware flow control set s1 rts/cts on
Software flow control set s1 xon/xoff off
Dial group set s1 group 1