Lucent Technologies PortMaster - Manual (Page 199)

Using ISDN BRI 12-15
ISDN BRI Unnumbered IP Configuration Example
Note – Configuring the maximum ports setting to a value higher than 0 causes the
PortMaster to dial out to a continuous location, or become available for dial-out to an
on-demand location. By configuring the maximum ports setting last, you ensure that
the PortMaster will not attempt to make a connection with a location until you have
configured all the settings for that location.
After you configure location table settings as shown in Table 12-7, enter the following
command to save the configuration:
Command> save all
For more information about configuring location table parameters, refer to Chapter 8,
“Configuring Dial-Out Connections.”
Configuring the PortMaster in San Francisco
The PortMaster in San Francisco is being configured for an ISDN dial-up connection to
the PortMaster in Denver.
IPX network set location sf ipxnet F3
RIP routing set location sf rip on
MTU set location sf mtu 1500
Idle timer set location sf idle 2
Dial group set location sf group 2
Username set location sf username sf
Telephone number set location sf telephone 5551212
Password set location sf password anypasswd
High-water mark set location sf high_water 0
Maximum ports set location sf maxports 1
Table 12-7 Location Table Values (Continued)
Setting Command
✍ ✍