Lucent Technologies PortMaster - Manual (Page 200)

ISDN BRI Unnumbered IP Configuration Example
12-16 PortMaster Configuration Guide
Configuring Global Settings
Configure the global settings to the values shown in Table 12-8.
After you configure the global settings shown in Table 12-8, enter the following
command to save the configuration:
Command> save all
For more information about global settings, refer to Chapter 3, “Configuring Global
Settings.”
Configuring Ethernet Interface Settings
Configure the Ethernet settings to the values shown in Table 12-9.
Table 12-8 Global Values
Setting Command
IP gateway set gateway 192.168.1.2
(This is the address of the next upstream router.)
Default routing set default off
System name set sysname sf
ISDN switch set isdn_switch ni-1
Table 12-9 Ethernet Value
Setting Command
Protocol set ether0 ipx enable
IP address set ether0 address 192.168.100.1
Netmask set ether0 netmask 255.255.255.0
IPX network set ether0 ipxnet F2
IPX frame type set ether0 ipxframe ethernet_802.2
Broadcast address set ether0 broadcast high
RIP routing set ether0 rip on