Lucent Technologies PortMaster - Manual (Page 226)

Configuration Steps for a Synchronous V.25bis Connection
14-4 PortMaster Configuration Guide
Configuring Global Settings
Configure the global settings to the values shown in Table 14-1.
After you configure the global settings shown in Table 14-1, enter the following
command to save the configuration:
Command> save all
For more information about global settings, refer to Chapter 3, “Configuring Global
Settings.”
Configuring Ethernet Interface Settings
Configure the Ethernet interface settings to the values shown in Table 14-2.
After you configure the Ethernet interface as shown in Table 14-2, enter the following
command to save the configuration:
Command> save all
Table 14-1 Global Values
Setting Command
IP gateway set gateway 192.168.1.1
System name set sysname boston
Table 14-2 Ethernet Values
Setting Command
IP address set ether0 address 192.168.200.1
Netmask set ether0 netmask 255.255.255.0
IPX network set ether0 ipxnet F1
IPX frame type set ether0 ipxframe ethernet_802.2
Broadcast address set ether0 broadcast high
RIP routing set ether0 rip on