Kerio Tech Firewall6 User Manual
Page 143
11.1 Web Interface Parameters Configuration
143
Advanced parameters for the Web interface can be set upon clicking on the Advanced button.
Configuration of ports of the Web Interface
Use the TCP ports section to set ports for unencrypted and encrypted versions of the Web
interface (default ports are 4080 for the unencrypted and 4081 for the encrypted version of
the Web interface).
Figure 11.2
Configuration of ports in WinRoute’s Web Interface
Hint
If no WWW server is running on the WinRoute host, the standard port of the HTTP protocol (i.e.
port 80) can be used for the unsecured web interface. In such cases, the port number is not
necessarily required in URLs for pages of the Web interfaces. However, the standard HTTPS
port (443) uses the Clientless SSL-VPN interface (see chapter
). Therefore, it cannot be used
for secured web interface in the default configuration.
Warning
If any of the entries are specified by a port which is already used by another service or ap-
plication, and the Apply button (in Configuration → Advanced Options) is clicked, WinRoute
will accept this port, however, the Web interface will not run at the port and an error in the
following format will be reported in the Error log (see chapter
):
Socket error:
Unable to bind socket for service to port 80.
(5002) Failed to start service "WebInterface"
bound to address 192.168.1.10.
If you are not sure that specified ports are free, check the Error log immediately after clicking
Apply to find out whether the corresponding error has been logged.