Siemens CX203isdn - Manual (Page 96)

95
System settings
SX303/353isdn / englisch / A31008-X353-B100-2-7619 / settings_bs.fm / 14.11.2005
Setting up the list of send MSNs for the next call
You can set up your base station so that after lifting the receiver or pressing the
handsfree key d a list of all available send MSNs is displayed.
By factory default, MSN next call is not activated.
Setting up a busy signal when the MSN is being used (Busy on Busy)
This setting allows callers to get a busy signal immediately when an external call is
already being made on this MSN, independent of the setting Call waiting.
By factory default, the function is not set.
i
Open the menu.
s
Set base
Select the menu item and confirm.
s
Settings
Select the menu item and confirm.
~
Enter system PIN if required (page 89).
s
Setup user
Select the menu item and confirm.
s
Setup device Select the menu item and confirm. The list of
entered internal numbers is displayed.
s
INT11: Int.11
W Select internal number of the terminal and open the
submenu, e.g. INT11: Int.11.
s
MSN next call Select the menu item and confirm (
‰
= activated).
j
Hold down (back to idle status).
OK
OK
OK
OK
OK
OK
i
Open the menu.
s
Set base Select the menu item and confirm.
s
Settings Select the menu item and confirm.
~
Enter system PIN if required (page 89).
s
ISDN settings Select the menu item and confirm.
s
Busy on busy
Select and confirm (
‰
= activated).
j
Hold down (back to idle status).
OK
OK
OK
OK
OK