Siemens CX203isdn - Manual (Page 124)

123
Operating with other devices
SX303/353isdn / englisch / A31008-X353-B100-2-7619 / devices.fm / 14.11.2005
Registering a repeater
Precondition: Gigaset Repeater has been deactivated (mains cable unplugged).
1. Prepare the base station for registration
The base station is ready for registration for as long as Registration proced.running is
shown in the display.
2. Plug the Gigaset Repeater into the mains
The LED on the Gigaset repeater flashes. The LED is permanently lit after a short time.
Registration is complete and the Gigaset Repeater is ready for use.
Further information is available in the operating instructions for the Gigaset Repeater.
Gigaset USB adapter DECT/M105 data module
The Gigaset USB adapter DECT/M105 with USB interface allows you to establish a
wireless connection between your PC and the base station. This enables you to surf the
Internet via a wireless connection to the PC.
A connection via a Gigaset M10x Data data module provides you with a 64 kbit/sec
interface.
The internal numbers PC 41 to PC 48 on your base station are provided for this
purpose.
For installation, see the installation instructions on the CD-ROM enclosed with the data
module.
i Open the menu.
s
Set base
Select the menu item and confirm.
s
Settings
Select the menu item and confirm.
~
Enter system PIN if required (page 89).
s
Setup user
Select the menu item and confirm.
s
Register device
Select the menu item and confirm.
OK
OK
OK
OK
OK
i Check that there are no other base stations that are ready for registration
in the vicinity of the Gigaset Repeater during this procedure.