Siemens CX203isdn - Manual (Page 16)

15
Preparing the base station for use
SX303/353isdn / englisch / A31008-X353-B100-2-7619 / starting.fm / 14.11.2005
two handsets (Int.13 and 14) and the answering machine AM 92 are intended for
private use.
Ring delay
When ring delay is activated, an incoming call is signalled on the base station after a
delay (e.g. after 5 ring cycles – the number is adjustable). Ring delay can be set
individually for each internal subscriber and for each receive MSN (page 103).
In the example, an incoming call to MSN1 is only to be signalled on handset Int.11 if
Int.12 does not answer the call. To achieve this, activate a ring delay for Int.11 and
MSN1 (e. g. 5 ring cycles). The call for MSN1 is signalled directly on Int.12, but is only
signalled on Int.11 after the 5th ring cycle.
Launching the Getting started wizard and setting the basic settings
You can operate the Getting started wizard for your base station either directly using the
base station or using an S44, S1 or SL1 handset.
Launching the Getting started wizard:
Internal users Use Receive MSN Send MSN
handsets Int.11, 12 Business MSN1 , MSN2 MSN1
Answering
machine
AM 91 MSN1 , MSN2 ---
Handset Int.13 Private MSN3 MSN3
Handset Int.14 MSN4 MSN4
Answering
machine
AM 92 MSN3 , MSN4 ---
i Open the menu.
s
Set base
Select the menu item and confirm.
s
Installation
Select the menu item and confirm.
[RRRRRRRRRRRRRRRRRRRRRRRRRR] YES
Press the display key to launch the Getting started
wizard.
If you already have set a system PIN (not 0000)
(page 89), you will be asked to enter it.
~
If required, enter the system PIN and confirm.
OK
OK
OK
i
◆ The Getting started wizard cannot be used simultaneously by multiple
internal users.
◆ If there is already settings data (factory default or previous settings),
this data is shown at the appropriate positions in the display and can
be modified there.
◆ To cancel the Getting started wizard, press the exit menu key and
hold. All changes you have already saved using Save entry §§OK§§ are
retained. The base station returns to idle status.
◆ To skip a setting, press the display key §NO§ .