Siemens CX203isdn - Manual (Page 27)

26
Making calls
SX303/353isdn / englisch / A31008-X353-B100-2-7619 / telephony.fm / 14.11.2005
Checking and deleting a callback
Deleting the callback while it is incoming
The base station rings and the display shows the callback number.
Checking or deleting the callback before it is incoming
Identify caller
Identify caller is used to identify annoying or threatening callers.
Precondition: You have applied for Identify caller with your network provider.
Activate this function during the call or immediately after the caller has hung up. You
must not end the call yourself.
The caller is identified in the telephone exchange and is recorded by phone number,
time and date. A printout of the list is sent later by your network provider.
[RRRRRRRRRRRRRRRRRRRRRRRRRRR] DELETE
Press the display key. The callback function is
cancelled.
i
Open the menu.
s
Set base
Select the menu item and confirm.
s
Status
Select the menu item and confirm. The status list is
displayed (
‰
= activated).
s
Callback Select the menu item and confirm. The current
callback number is shown on the screen.
either ... Check:
[RRRRRRRRRRRRRRRRRRRRRRRRRRR] BACK
Press the display key. The callback remains active.
or ... Cancel:
[RRRRRRRRRRRRRRRRRRRRRRRRRRR] DELETE
Press the display key. The callback function is
cancelled.
OK
OK
OK
i
◆ You may not replace the receiver!
◆ To make this function easier to use, you can also set one of the
function keys accordingly (page 115).
i
Open the menu.
s
Identify caller
Select the menu item and confirm. OK