Restoring the factory settings – Siemens CX203isdn User Manual
Page 109
108
System settings
SX303/353isdn / englisch / A31008-X353-B100-2-7619 / settings_bs.fm / 14.11.2005
Calling an answering machine in the network (on CX203isdn)
Press
1 and hold. You are connected directly to the answering machine in the
network. If you then press the handsfree key
d, you can listen to the answering
machine announcement in the network and operate the answering machine via the
network.
Changing the answering machine number in the network
Viewing/listening to answering machine messages in network
If a message arrives for you, you receive a call from the answering machine in the
network. The number, e.g. 0800 330 2424 for T-NetBox, appears in the display if you
have requested calling line identification. If you accept the call, the new messages are
played back. If you do not accept the call, the number of the answering machine in the
network will be stored in the missed calls list and the message key flashes.
Restoring the factory settings
You can select which type of reset should be performed:
Operational
– All MSNs and access codes (outside line code) are deleted and the AM
(answering machine) PIN (only on Gigaset CX253isdn) is set to 0000. The authorisations
are reset to "Dial and answer".
Reset all
– All functions are reset to their factory defaults. The system PIN is reset to
"0000". All entries (caller list, charges) are deleted.
i
Open the menu.
s
Set base
Select the menu item and confirm.
s
Settings
Select the menu item and confirm.
~
Enter system PIN if required (page 89).
s
System settings
Select the menu item and confirm.
s
Network Mailb.
Select the menu item and confirm.
W
Open the submenu.
s
Change number
Select the menu item and confirm.
~
W
Enter country code and open the menu.
s
Save entry
Select the menu item and confirm.
OK
OK
OK
OK
OK
OK
OK
i
For both functions: Deactivate all active call diversions before resetting!
The terminals remain registered.
i
Open the menu.
s
Set base
Select the menu item and confirm.
s
Settings
Select the menu item and confirm.
OK
OK