Siemens CX203isdn - Manual (Page 63)

62
Operating the answering machine (on CX253isdn)
SX303/353isdn / englisch / A31008-X353-B100-2-7619 / answeringm_use.fm / 14.11.2005
Activating/deactivating the answering machine
You can only activate/deactivate an answering machine when time control is not active
(page 79).
Precondition: You have selected an answering machine (page 61).
When activating, the remaining memory time (in %) is shown on the display.
Which AM mode the answering machine assumes after activation (answer and record
mode or announce only mode) depends on the announcement selected (page 62).
You can only activate an answering machine in answer and record mode if there is
memory still available. If the remaining memory is less than 60 seconds, you will be
prompted to delete old messages. When the remaining memory is less than 10 seconds,
the answering machine is started in announce only mode.
If the answering machine is activated the
ö key is illuminated.
Selecting announce only and AM mode
You can activate Announcement 1, Announcement 2 or Announcem. only for each
answering machine. As supplied, the three announcements already contain standard
announcements.
When you select an announcement you also determine in which AM mode the
answering machine is to run (page 61).
◆ Announcement 1 , Announcement 2: Answer and record mode
◆ Announcem. only: announce only mode
In answer and record mode a Concl.announcem is given automatically at the end of a
recording provinding you have recorded a concluding announcement (page 63).
When the phone is supplied Announcement 1 is selected. The Concl.announcem
contains nothing.
Precondition: You have selected an answering machine (page 61).
either ... Activate the answering machine:
s
Activate?
Select the menu item and confirm.
or ... Deactivate the answering machine:
s
Deactivate?
Select the menu item and confirm.
OK
OK
s
Announcements
Select the menu item and confirm.
s
Announcement 2
Select announcement, e.g. Announcement 2
(
‰
= activated).
W Press the display key to open the submenu.
Select
Confirm. The previously set announcement is
automatically deactivated.
OK
OK