De-registering handsets, Gigaset repeater, Activating/deactivating repeater mode – Siemens CX203isdn User Manual
Page 123: De-registering handsets gigaset repeater
122
Operating with other devices
SX303/353isdn / englisch / A31008-X353-B100-2-7619 / devices.fm / 14.11.2005
De-registering handsets
Gigaset Repeater
You can increase the range of your handsets with the Gigaset Repeater. You can operate
up to six repeaters on your base station. To ensure the repeater is installed correctly,
repeater capability must be activated on the base station.
Activating/deactivating repeater mode
You can use this function to activate and deactivate repeater mode.
By factory default, this repeater capability is deactivated.
i
Open the menu.
s
Set base
Select the menu item and confirm.
s
Settings
Select the menu item and confirm.
~
Enter system PIN if required (page 89).
s
Setup user
Select the menu item and confirm.
s
De-reg. device
Select the menu item and confirm.
s
INT16: Int.16
Select the handset that you wish to de-register and
confirm, e.g. INT16: Int.16.
j
Hold down. Return to the idle state.
OK
OK
OK
OK
OK
OK
i
Open the menu.
s
Set base
Select the menu item and confirm.
s
Settings
Select the menu item and confirm.
~
Enter system PIN if required (page 89).
s
System settings
Select the menu item and confirm.
s
Spec. function
Select the menu item and confirm.
s
Repeater
Select the menu item and confirm.
[RRRRRRRRRRRRRRRRRRRRRRRRRRR]
NEXT
Press the display key to save the setting. The handset
goes off briefly (
‰
= activated).
OK
OK
OK
OK
OK
OK