Siemens CX203isdn - Manual (Page 107)

106
System settings
SX303/353isdn / englisch / A31008-X353-B100-2-7619 / settings_bs.fm / 14.11.2005
By factory default, Internal is activated.
Activating/deactivating Call beats data
With Call beats data you can set whether a call is rejected or signalled during data
transmission.
◆ Call beats data Off (default):
Calls received during data transmission are rejected if both B channels are being
used simultaneously. The caller will hear the busy tone.
◆ Call beats data On:
If a call is received during data transmission, the data connection is automatically
reduced to one B channel and the call is signalled.
Changing the long distance prefix
Long distance prefixes are the first few digits required when dialling another city
(national) or to another country (international). In Germany, the factory default is:
In other countries, different long distance prefixes could be used. In this case you need
to change this setting.
Otherwise, you would not be able to make some calls, e.g. callbacks from the call list.
i
Open the menu.
s
Set base Select the menu item and confirm.
s
Settings Select the menu item and confirm.
~
Enter system PIN if required (page 89).
s
System settings Select the menu item and confirm.
s
Music on hold Select the menu item and confirm.
s
Internal Select and confirm the desired setting, e.g. Internal
(
‰
= on).
j
Hold down (back to idle status).
OK
OK
OK
OK
OK
OK
i
Open the menu.
s
Set base
Select the menu item and confirm.
s
Settings
Select the menu item and confirm.
~
Enter system PIN if required (page 89).
s
ISDN settings
Select the menu item and confirm.
s
Call beats data
Select the menu item and confirm (
‰
= on).
OK
OK
OK
OK
OK
0 For connections to other towns (national)
00 For connections abroad (international)