Siemens CX203isdn - Manual (Page 128)

127
Appendix
SX303/353isdn / englisch / A31008-X353-B100-2-7619 / appendix.fm / 17.11.2005
Appendix
Care
Wipe the base station and handset with a damp cloth (do not use solvent) or an
antistatic cloth. Never use a dry cloth. This can cause static.
Contact with liquid
If the handset should come into contact with liquid, on no account switch the device
on. Remove all batteries immediately.
Allow the liquid to drain out of the device, and then pat all parts of the device dry.
Keep the handset with the batteries removed in a warm, dry place for at least 72 hours.
In many cases, you will then be able to use it again.
Questions and Answers
If you have any questions about the use of your phone, you can contact us 24/7 at
www.siemens.com/gigasetcustomercare. You will find the most frequently asked
questions and answers below.
!
What has happened
when …
Possible Cause Possible solution
… the base station does not
ring?
The ringer is switched off.
Internal call diversion is set to 0
ring cycles (= immediate call
diversion).
Night service is active.
Activate (page 112) ringer.
Increase the number of ring
cycles for internal call diversion
(page 98).
Deactivate Night service
(page 86).
… the call units/charges are
not displayed?
There are no metering pulses.
Factor per unit = 0.
Ask your network provider to
transmit the metering pulses.
Set the factor per unit
(page 44).
… the phone number of the
caller is not displayed even
though CLIP is set?
Calling Line Identification is
blocked.
The caller must ask his network
provider to enable the
identification of his number
(CLI).
… the caller list does not
indicate a time for a
message?
Date/time are not set. Set the date/time (page 84).
… the answering machine
does not record any messages
or has automatically switched
over to 'announce only'?
Its memory is full. Delete old messages
Play back new messages and
delete.
… you can't dial a phone
number any longer?
The long distance prefix has
changed.
Check the long distance prefix
and correct it (page 106).
… there are no incoming
calls?
Call diversion Immediately is
activated.
The MSN has not been assigned
to the internal user.
The authorisation Internal only
is set.
Deactivate Immediately call
diversion (page 98).
Determine the receive MSN
(page 94).
Change the authorisation
(page 90).