Siemens SX763 - Manual (Page 33)

33
The user interface
Gigaset SX763 WLAN dsl / en / A31008-M707-R131-2-7619 / configure_router.fm / 08.12.2006
Sc
hablone 2
005_0
5_02
A page with security information will appear. You can skip this when configuring the
device for the first time. If you carry out all the general and security settings using the
wizard as described below, your device and network will be fully protected. If not, the
next time you log on you will be informed of security gaps in the configuration program.
ì
Click OK.
The start screen
The start screen is the starting point for all configuration and administration proce-
dures.
Start screen functions
You can make the following settings on the start screen:
u Select the language for the user interface (page 35),
u When you have configured an Internet connection for the first time, you can view
the selected connection service and the status of the Internet connection, choose a
different connection service and set up or close an Internet connection (page 35).
Depending on the connection mode selected, the start screen shows the status and
also the button Connect or Disconnect,
u Open the Status menu to obtain status information about the Gigaset SX763 WLAN
dsl (page 111),
u Call up the wizard for the basic configuration (Basic Setup Wizard see page 37),
u Call up the Security Setup Wizard (page 44),
u Open the Advanced Settings menu for additional configuration options (page 53).
You can call up the wizards, the Advanced Settings menu and status information at any
time and on any user interface screen using the tabs at the upper margin of the user
interface.
Note:
For security reasons you should change this password at a later stage (page 45).